Apr 23 2008

Ask Questions

Published by admin

If you have an Automotive related question and need answers fast then you have found the right place. You can have your questions answered by experts 24/7.  >>>>>Ask Here<<<<<

 

GET AN ONLINE REPAIR MANUAL FOR YOUR CAR – Get on-line access to drive belt routing, repair instructions, wiring diagrams, trouble code diagnostic charts and updated factory bulletins.

7 responses so far

7 Responses to “Ask Questions”

  1. # RaymondPowerson 08 Jul 2008 at 11:31 am

    I just replaced my pistons, rings and connector rod bearing and still have a knock. What could it be?

  2. # adminon 09 Jul 2008 at 4:59 am

    “Main Crank Bearings”

  3. # bigvicon 31 Aug 2008 at 2:30 pm

    i was running my car with no oil and a noise came that sounds like a rock is it in. i changed the oil but still nothing. what could it be? its a 2000 toyota celica gt 5spd and when you crank it the noise comes on and the rpm doesnt rise so you can only be on 1st gear

  4. # adminon 02 Sep 2008 at 1:22 am

    “You have damaged your engine internally and it will need to be rebuilt. The only way to be certain of what parts are damaged are to take it a part. Most likely you have damaged a rod bearing form no oil.”

  5. # jaredon 08 Oct 2008 at 7:00 pm

    I replaced a front tranny seal and put it all back together and it still leaks. could I have put in a defective seal or could there be another problem that could cause tranny fluid to leak

  6. # adminon 09 Oct 2008 at 4:26 am

    More than likely the seal is fine, you need to install a “speedy sleeve” over the worn shaft of the converter. This is if there is no play in the transmission front shaft bearings. If you can move the front shaft up and down then your shaft bearings will need to be replaced.

  7. # rladkins25on 29 Nov 2008 at 9:13 am

    hi i,m new to this site my ??? is i have a 97 honda civic and i wanna put a high flow racing cat on it but i was told if i did that it would mess my car up is this true