Aug 04 2010

1990 ford ranger fuel pump will not run

Published by admin at 12:49 am under Articles,Auto Repair,FORD

I have a 1990 ford ranger with a 2.3 liter. My fuel pump will not work.I replaced the pump,relay and the batteries ground cable.I have a wire that runs from the ground on battery to the fuel pump relay he is getting about 8 volts could you help me find the problem? thanks

Response:
Check the inertia switch (fuel cut off switch) This switch shuts off the fuel pump in the event of a collision. Once the switch has been tripped, it must be reset manually in order to start the engine.

The inertia switch is located on the toe-board, to the right of the transmission hump, in the passenger-side footwell.

But your relay should see battery voltage on the BLK/YEL wire that comes from a 30 amp fuse#1.
The RED wire that goes to READ ENTIRE ARTICLE

Comments Off

Comments are closed at this time.