Nov 13 2008
heater blower fan only works on full speed
I have a 2003 Kia Sorento,and the heater blower fan only works on full speed. The display on the dash shows the other speeds when selected but the fan does not run. I assume a problem with the speed controll or rheostat, but where is it located?
Answer:
The rheostat is now known as the resistor.
I personally have never seen a Sorento diesel so if this resistor is in the same spot as other gas engine Sorentos I’m not sure.
However, you have to lower the glove box door. There is a strap on the right and 2 stop grommets, one on each side of the glove box. Push the stops forward to release and pull them out. If you look close you’ll see what I mean. Just pull and twist the end of the strap to remove it.
Leave a Reply
You must be logged in to post a comment.
